Point 2 Point

Mark multiple points when drilling, dowelling, biscuiting/flat doweling, pinning and much more.

When working out the correct number and position of dovetails, biscuits, dowels, screws, pins or splines, or calculating the maximum number of strips that can be cut from a board, dividing must be done, and if it's for exposed joinery like dovetails, pins, or screws that will be covered with decorative plugs, it really helps to be able to see the divisions before you start marking up the wood surface, does it not? Instead of messing about with calipers or a calculator and marking things up only to erase and sand them away, simply extend the Point-2-Point™; to give an instant visual guide to locations.

Point-2-Point™; has a four-point locking mechanism so you can transfer your locked measurements between boards and over larger areas, and eight stainless steel uprights which expand to a maximum length of 2ft (600mm). With the Point-2-Point™;, you can visually design and mark decorative details, joinery, rip lines, loose tenons, or anything else with a glance and a few strokes of a pencil or marking knife.