Veritas Wheel Marking Gauge
The hardened steel cutter will perfectly scribe at any point of its circumference. Since the wheel cutter is sharp, bevelled only on the inside and non-rotating, it cuts through grain and forces the gauge face against the stock, maintaining accuracy.  Because it cuts rather than tears, it leaves a clean mark, even on cross grain. It has an internal O-ring to keep light but constant friction on the stem. The anodised aluminium head has a 1/8" thick brass face and a brass thumbscrew. Two models are available. The standard gauge has an unmarked rod and the graduated gauge has a rod graduated to 150mm in 1mm steps.

Please Choose: